Kit-build Dix 470 Plywood Catamaran

Assembly of the prototype This long outboard hull panel was pre-assembled into one large piece before installation.

Bottom panels were fitted installed.

The side panels were glued into longer lengths for convenient assembly with the equipment available to Exocetus. For my own projects and more primitive methods, I prefer to assemble skin panels in single-sheet lengths. This leaves considerably more scope for adjustment during installation to remedy any possible errors that arise due to builder error. The bottom panels were installed in single-sheet lengths, to allow accurate fitment at the centreline joint.

In the last photo above, the jigsaw joint was aligned using a strip of plywood, wrapped in plastic tape, as a temporary butt-strap. A short screw into each lobe of the jigsaw pattern ensured accurate assembly and held the joint securely until the epoxy had set.

For more info on this and our other designs, visit / . For more info on the kit and options, go to http://exocetus.net/ .

Related Posts by Categories